Reset Post Submit Post. Please verify your product is powered on and connected, then try again in a few minutes. Nothing ever printed even when I raised the job priority to I heve tried to set up and the computer found the port; however, when I tried to print the test page, it won’t print and said networking trouble. However, the response, from an HP engineer, suggested that the user ring HP to discuss the problem.
|Date Added:||1 May 2009|
|File Size:||14.84 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The jetdirect card can be located in the back of the printer–there are a couple of screws to loosen, but it shouldn’t be too bad.
Email list of drivers. I don’t see my operating system. This product detection tool yp4550n software on your Microsoft Windows device that allows HP to detect and gather data about your HP and Compaq products to provide quick access to support information and solutions.
HP 4550n Toner
I still think it must be something in the control panel that I need to reconfigure. Any help to resolve this issue will be appreciated.
Installing an HPn networked printer – TechRepublic
Did you happen to notice if the data light flashed when trying to print the directory to lpt1? I’ve tried changing the port, add new hardware, nothing works.
Europe, Middle East, Africa.
This resolved the error, and allowed Wingate to install successfully, I hp4550nn hoping it may also enable the successful installation of the driver for the printer. Thank you for your patience.
I assume the instructions would be reversed once I obtain a new router. We were unable to retrieve the list of drivers for your product.
Yellow Laser Toner Cartridge for HP N (HP Model # CA)
The driver I want to install will provide a direct network connection. We were unable to find any drivers for your product. Previously, I had tried to install Wingate, and kept getting a Winsock error. A direct network connection can be established between the printer and another computer.
While I haven’t worked with a other hp printers allow you to reset the ip by holding the reset button for 90 seconds and then restarting and hold the button again, this clears the old addresses so the install of the network software will load the new your domain adress. I can not get the PC to recognize the printer. The problem comes I thinkwhen the install program tries to create a port on my computer through which the printer data is to be routed.
My printer network connects directly to the DSL modem. Thank you in advance!
Reset Post Submit Post. Operating System – Windows 7, Windows 8, Windows 8. You may want to change the prompt to C: The solution was to completely remove all networking protocols etc. HP Download and Install Assistant. If you don’t want to reset the configuration settings, you can take the jetdirect card out first before performing the “cold reset. If this does not help, try shutting the printer down and then restarting holding the “Go” button as the printer starts. Point value changed by question poster.
Track this discussion and email me when there are updates.