The firmware used to be in linux-firmware-nonfree, but it had been removed the last time I looked. Requires latest Ralink RT source drivers, modification instructions can be found here. I’m new to linux. Find More Posts by michaelk. Using ndiswrapper, could not load. In Feisty installing Broadcom firmware here will get v. In Fiesty, it works, but not with WPA.
|Date Added:||16 August 2008|
|File Size:||21.99 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Then I noticed that I was having some instability, especially after I upgraded to the latest versions of the Linux kernel, and as I tried different things to find a fix, I came to the conclusion that ndiswrapper was the culprit.
Linksys WPC54G v1.0
May 26th, 7. Join our community today! Yes In Ubuntu To do this when Ubuntu starts, open the restricted drivers management and enable bcm43xx. Ubuntu Forums Code of Conduct. Supported in installed system?
Couldn’t get any of the windows drivers from linksys. Following downloads and install, you should be up and running note: This card is version 1. Tested on Ubuntu 7. After setup completes, the card is shown in the network interfaces as eth0, all hardware details are shown toobut the system is unable to activate it. On 64 bit system, native support with brcmfmac for this chipset did not work. Linisys On Amazon Ubuntu Then do “ifconfig” in a terminal to see if the wireless card has picked up an IP number from your wireless router.
In Fiesty, it works, but not with WPA. Linksys WPC54G v3 Luckily, there’s a B43 firmware update available.
HardwareSupportComponentsWirelessNetworkCardsLinksys – Community Help Wiki
Find More Posts by Rod M. To install it, get connected to a wired connection, open a terminal and type these commands: I have a WPC54G ver. Email Required, but never shown. I’m new to linux.
That worked OK, and I ran ndiswrapper for a while. WPA works with ndiswrapper according to this howto: The more you use Linux: I’ve read several posts and tried liknsys suggestions but nothing seems to help the specific hardware I’m using. Updating the firmware link broken fixes the problem.
One may use ndiswrapper with the Windows driver from linksys but not the version for Vista. May 26th, 5. After installing the card, I wireless-b to enable “Broadcom STA wireless driver” in the hardware drivers manager. Partners Support Community Ubuntu.