SYNTAX USB CARD READER UCR-61 DRIVER

The behaviour of Active LED will be somewhat strange – it will light up only if the system detected the device, so if you “safely remove” it, light will go out The posting of advertisements, profanity, or personal attacks is prohibited. Enter the e-mail address of the recipient Add your own personal message: ND Datasheet it’s hard to get this Back to home page Back to hacks. You are logged in as. Once reported, our staff will be notified and the comment will be reviewed. Solder a black wire to remaining LED1 hole.

Uploader: Groshakar
Date Added: 27 February 2011
File Size: 38.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67134
Price: Free* [*Free Regsitration Required]

Promote cracked software, or other illegal content. Connect the pads using only solder.

Syntax UCR 61 USB Card Reader

Login or create an account to post a review. It also needs its own driver. Yes, they are about 60Ohm resistors cut down using a flat file to suit my needs. Please submit your review for ucr This package supports the following driver models: You probably can use it in Windows by installing this driver i haven’t tried it! Unsolder active LED wires. You have to remove this resistor with code and connect the pads below in fact you’re changing a logic state of Neodio’s pin Another picture of everything inside: Connect R28, Ohm goes to R38 if there isn’t.

Recent Drivers  M2727 PRINTER DRIVER DOWNLOAD

Enter the e-mail address of the recipient Add your own personal message: Your message has been reported and will be reviewed by our staff. First, remove a piece of thermal glue being careful not to rip any SMD components with it. In this document I’ll show how to make this reader more universal and how to add some visual hacks.

R35 should be also near Ohm. Remove an upper plastic part above CF card slotyou should see a complete mainboard. Select type of offense: Solder a black wire to remaining LED1 hole.

Syntax UCR 61 USB Card Reader | eBay

You are logged in as. Once rrader, our staff will be notified and the comment will be reviewed. Unsolder the resistor by heating one of its ends at time, lifting it a bit using a sharp knife or tweezers. Mainboard ID data is stored in this chip, alongside with access methods which means how the device is controlled by a driver.

Recent Drivers  DSL-2520U DRIVER DOWNLOAD

If there’s no resistor in R26, there must be about Ohm. We have to make it another way: The behaviour of Active LED will be somewhat strange – it will light up only if the system detected the device, so readr you “safely remove” it, light will go out First, remove two screws from the reader.

LED2 lights up when SmartMedia slot is active. All my content and ptohos.

PC Chips UCR-61 Free Driver Download

Thank You for Submitting Your Review,! Link R42, connect like LED4.

Now remove cables from it, so it’ll move along a LED wires. Advertisements or commercial links. Thank You for Submitting a Reply,!