Tuesday, September 20, 4: This site uses cookies for analytics, personalized content and ads. Give it a go and see how you get on. When I delete the ‘error – printing’, after long time the print job is deleted and the exclamation-mark is back to ‘very-good’ sign. Not an IT pro? Make sure you check the vendor site for 64bit drivers for this hardware.

Uploader: Mokinos
Date Added: 17 June 2018
File Size: 44.33 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41177
Price: Free* [*Free Regsitration Required]

The print queue of your printer should now be cleared. You can request configuration and status from the printer, and the printer can send unsolicited status such as “Paper tray empty” to the client.

Aten Fully Bidirectional

Not an IT pro? Saturday, September 24, 9: Sign in to vote. But do not know then how to get them back except doing a Restore Point. Normally this issue comes back to the cable. I’m afraid I’ve already tried this without success.

USB to IEEE Printer Adapter (m) – UCB, ATEN USB Converters

For others to beware of like Alan mentioned its: I installed an HP diagnostic program and first winsows ‘Connectivity’ did not pass later following other tests if connectivity passed. Tuesday, September 20, 6: Monday, September 26, I assume you are windoww directly to the computer and not through a USB hub.


Maybe I try to delete in ‘Devices and Printers’: Just from your description, the failure is during the write to the port monitor. A queer thing also happened after I got it working.

By doing this, you should be able to print. At this point it’s time to find out if the cable works on 32bit Windows 7 or not on XP 64bit.

Verify you setup the printer port to USB00n. Make sure you check the vendor site for 64bit wlndows for this hardware. Some parallel ports are set by default to IBM AT-compatible mode; you need to change the setting to bidirectional. The difference if it had anything to do with it I’ve noted was that when I did not shut-down and boot-up again, 2 more ports where displayed in Printer Properties under Ports: Remove From My Forums.

Also very keen spotting out the ‘prtiners’, thanks. Sorry Alan, skipped the ‘Enable Bidirectional’ comment.

Right-click the bidirectional printer, and then click Properties. The cable off technet http: Tuesday, September 20, 1: I assume that the printer light does not flash when you are “printing”.


The language monitor provides the common kc1284b needed for the client and printer to understand each other in bidirectional communication, so you can configure the printer and monitor printer status. I was eventually tempted to give up but finally met with a solution. You should get a confirmation that the print spooler is stopping.

I assume you are using the off Windows Update. When I delete the ‘error – printing’, after long time the print windwos is deleted and the exclamation-mark is back to ‘very-good’ sign. It is not highlighted with only the cable attached.

Alan Morris Windows Printing Team.